Two-dimensional paste inspection came first, often as a camera built into the printer. It answers a useful question: is there paste on the pad, and is it in the right place? Three-dimensional inspection answers the question that matters more for the solder joint: is there the right amount?
What each one measures
| Measurement | 2D | 3D |
|---|---|---|
| Area coverage | Yes | Yes |
| Position and offset | Yes | Yes |
| Bridging | Yes, by contrast | Yes, by height |
| Height | No | Yes |
| Volume | No (estimated from area) | Yes, measured |
| Shape defects such as dog-ears and scooping | No | Yes |
Why area is not enough
A 2D system that reports volume is multiplying measured area by the stencil thickness and assuming the deposit is a perfect brick. Real deposits are not. Paste that sticks in the aperture leaves a deposit with full area and half the height. Excess squeegee pressure scoops paste out of large apertures. Poor separation pulls up peaks at the edges. In each case the area looks fine and the volume is wrong.
Volume is what becomes the solder joint. Too little gives an open or a weak joint; too much gives a bridge. Height and volume are also the first measurements to move when a stencil begins to clog or board support is inadequate, so they give the earliest warning.
Where it matters most
- Fine-pitch and small passive components, where the volume tolerance is tight in absolute terms.
- Area-array packages such as BGAs and QFNs, where the joints are hidden after reflow and cannot be inspected optically.
- Small apertures with low area ratios, where incomplete paste release is common.
- High-reliability products, where a marginal joint that passes test is still a failure waiting to happen.
How 3D measurement is done
Most 3D systems project light at an angle and observe how it shifts over the deposit. Laser triangulation scans a line across the board. Structured-light systems project a pattern over an area and reconstruct a height map of the whole field of view at once. Both give true height; they differ in speed, resolution and sensitivity to surface conditions.
Is 2D ever the right choice?
A printer’s built-in 2D check is worth using for gross errors such as a blocked aperture or a badly misaligned print. For large-pitch boards with generous process windows it may be all that is needed. As a basis for process control on anything finer, it leaves the most important variable unmeasured.
If the purpose of inspecting paste is to predict the solder joint, measure the thing that forms the joint: volume. That requires 3D.